Volantex ASW28 Glider 2.6m PNP

The V2 ASW-28 is a foam and plastic hybrid model with some nice upgrades over the V1. The wing set and tail are made of EPO foam, while the fuselage is made of blow molded plastic, which should provide a good mix of durability and performance. This version includes a servo motor and controller (esc). You only need to get your own radio system and a 3S 1800-2500mAH Li-po battery to get started.

The battery is accessible after removing the canopy/cabin, which is secured with a snap lock. The wings now have two attachment bags to provide extra rigidity during looping and high bank speeds. The wings are also easier to assemble with a plastic lock that holds them in place. The battery and radio compartment has been expanded compared to the V1, allowing you to add FPV gear if you like. The V2 has also been upgraded with better rubber wheels that make it easier to land on hard runways and short grass.

Features:

• Durable Build: EPO foam wings and tail
• PNP version, complete with pre installed electronic components (motor, servo, control (ESC).
• Brushless 4023-1050kV Out runner motor.
• Controller: 2-3S 30A BEC 5A brushless controller.
• Servos: 6x9 gram servos.
• Large battery and radio compartment makes it easy to install FPV equipment
• Foldable propeller of 10"x6" (25.4x15.2 cm)
• Pilot Figure: A stylish pilot figure is included
• Detailed instructions

Specifications:

• Wingspan:         2600mm (102.4 in)
• Overall Length: 1132mm (44.5 in)
• Flying Weight:  1050g
• Prop Size:         1060 folding Propeller
• Motor Size:       4023/1050KV
• Speed Control:  ESC 30A
• Servo :              9g Servo x 6pcs

Required to Complete - Sold Separately:

• Recommended Battery: 11.1V 2200mAh Li-Po
• Charger: LiPo charger
• Transmitter: 2.4Ghz 6 Channels
• Receiver
• Battery Charger
• Batteries: 4 x AA for the transmitter